Created with Sketch. Created with Sketch.

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Toggle menu
(828) 430-4510 or Toll Free 1-866-248-0100

Shop by Category

Accessories for X-20 and discontinued MU-2 models

  • Inside-Corner-Fences-Hoffmann-W3011004 Inside-Corner-Fences-Workpiece-Hoffmann-W3011004

    Inside Corner Fences for X-18, X-20, MU2 and MU-3 series

    Hoffmann Inside Corner Fences are one of the most commonly ordered accessories they are used for wider moulding requiring two Dovetail Keys per joint.Shipped in a set of two, one for the left and one for the right hand side. Will fit on X-20, older MU2...

    $146.00
  • Fence Plate for X-20 & MU2 - custom angle (W3090000)

    Fence Plate for X-20 & MU2 - custom angle

    SPECIAL ORDER ITEM Steel fence plate, machined edges with custom angles to customer's specifications Will work with X-20, MU2 and MU2-P machines Tip: A light coating of butcher block wax will keep the plate from rusting!

    $246.00
  • Fence Plate for X-20 & MU2 - 67.5° - for flag cases (W3090675) Flag Case, mfg. by Spartacraft and joined with Hoffmann W-1 Dovetail Keys

    Fence Plate for X-20 & MU2 - 67.5° - for flag cases

    Special Order Item! Steel fence plate, machined edges with steep 67.5 degree sides, with black finish for joining miters in flag display cases (isosceles triangles - two angles are the same (67.5 and tow sides are the same length) Will work with X-20,...

    $246.00
  • Hoffmann Center Line Locator (W3010003) Center Line Locator (W3010003) - example 1

    Center Line Locator

    Designed for quick installation on newer X-20 and MU2/MU2-P bench-top routing machine Note: Newer X-20 models have a machined flat area on the router carriage to allow installation of Center Line Locator - older models may not have this machined area...

    $49.30
  • Mullion Jig for MU2 and MU2-P models (W3012000) Mullion Jig installed on MU2-P (W3012000)

    Mullion Jig - only for MU2 and MU2-P models

    Mullion Jig machined out of solid aluminum - fits only on MU2 and MU2-P models. Designed with steel guide blocks to register in groove on machine table Jig is just slightly lower than rear fence on MU-2 machine to allow the bottom edge of the coped...

    $275.00